ElectricMotorcycleForum.com

  • September 02, 2026, 09:48:26 PM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  

News:

Electric Motorcycle Forum is live!

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - bumpp

Pages: [1]
1
Thanks for the feedback guys.

It turns out I was not eligible to bid without enlisting a broker anyway.  I did watch the auction though, it went for $1400 "on approval", if anyone is curious.  Which is too bad, because that number was below my pain threshold.  Beforehand I dropped the $6 for an autoautions.io report, and the insurance company previously rejected a $2200 high bid because it didn't hit the reserve.  So either some insurance guy made a bad call and missed out on $800, or it will be up again later.

I've watched the Rich Rebuilds Zero saga.  And also the Samcrac auction dealings and his videos about deceptive auctions, which is why I was looking for any possibility for the battery to not be legit.  Even if the cells were present, there was no way to tell they weren't junk / depleted beyond recovery as I would have been unable to personally inspect it due to location.

And your logic makes sense, any EV conversion enthusiast thief looking for just cells would harvest more than just cells, and take the pack as a complete unit.

Thanks again for your input! On to the next one! :)

2
Hi guys,

New member here with a "drive by" question, hope you don't mind the noise.

There is a theft recovery 2017 FX up for auction on copart tomorrow, which I am interested in for an ATV EV conversion: https://www.copart.com/lot/49627529

The battery pack looks to be intact (with maybe a bit of a dent...), I'm wondering if it would be possible for a thief to remove the cells while leaving the battery casing behind (for the insurance company to later reassemble into a seemingly present pack)?

I've been all through the unofficial manual wiki, and have plied by best googling skills, with this youtube video showing the best internal view of a pack I can find:   This is obviously not the same pack, and possibly just a brick from a bike other than the FX.

Does the epoxy potting material make removing the sides of the FX 7.2 pack impossible without deforming them?

Thanks again

Pages: [1]