Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - spalardy

Pages: [1]

Zero Motorcycles Forum | 2013+ / Re: wheel bearing replacement issues

« on: November 05, 2018, 08:14:06 AM »

I had to replace the rear bearing in my 2013 Zero S after 12 000 miles. The dealer says that I could not change the bearing only and had to change the whole entire wheels with the bearing. It has cost me 340 $ canadian + 90 for installation.

Zero Motorcycles Forum | 2013+ / elcon charger 2500 for zero moto s 2013

« on: February 09, 2018, 09:04:33 AM »

I'm looking for someone that sell an elcon charger 2500w tune for zero moto s 2013 or another charger model with the same outpout capacity. I have called hollywood electric but they don't sell this charger anymore. I don't want to buy a zero moto 2017- 2018 to have a quick charging solution on the road.

Buy Sell Trade / Re: SOLD: New ELCON 2500 for Zero's

« on: February 05, 2018, 08:21:41 AM »

Hi. I'm pretty sure that your elcon charger is already. I'm looking to buy an elcon 2500 charger for zero moto ds 2013. I called holywood electric yesterday. They were the specialists to set this charger for zero moto. They don't sell it anymore. Can you tell me where you bought your charger or what were the exact specifications to buy it online ? For example the charging curve, voltage... i'm really not good in electronic and I don't want to order the wrong charger. The delta-q sold by zero moto does not have a lot of watts to charge the moto quickly on the road.

Tech Help / Re: Controller Area Network (CAN) Error

« on: May 10, 2017, 08:40:19 PM »

Hi, just to report that I had the same problem yesterday (CAN Bus Error) with a Zero Moto Type S (2013) when the temperature was minus 3 celsisus over the night. I try to use my moto the next morning and I had CAN Bus Error. Was not able to start and not able to charge the moto. The read light indicator was flashing 2 times and 3 times just after. The problem was auto fixed in the afternoon when the temperature was 6 celsius.