1
Zero Motorcycles Forum | 2013+ / Re: SR/S Steering Head Bearings and Fork Specs
« on: November 30, 2022, 12:15:29 AM »
Thanks! That's very helpful.
I did note that although the SR manual says 102 Nm, if you look at the procedure, it still says 81 Nm which matches the FX manual. I am thinking that the value shown in the table is just a typo, because then the torque values would be the same for all bikes.
For reference, the locknut requires 68 Nm to seat, then back off to hand tight and retorque to 34 Nm. Loctite 609 is used on the bearing inner and outer races.
It looks like Showa SS No. 8 oil is shown for all the bikes, although the oil volume and level is unique to each bike.
I did note that although the SR manual says 102 Nm, if you look at the procedure, it still says 81 Nm which matches the FX manual. I am thinking that the value shown in the table is just a typo, because then the torque values would be the same for all bikes.
For reference, the locknut requires 68 Nm to seat, then back off to hand tight and retorque to 34 Nm. Loctite 609 is used on the bearing inner and outer races.
It looks like Showa SS No. 8 oil is shown for all the bikes, although the oil volume and level is unique to each bike.