ElectricMotorcycleForum.com
Makes And Models => Zero Motorcycles Forum | 2013+ => Topic started by: raystl on June 03, 2019, 11:56:10 PM
-
After installation in my plane I’m getting the safety interlock dash flash. A dump shows a Tipover error.
- Tipover Sensor Vector : -21, 152, 196 - 248/256 G
- Tipover Sensor Roll Angle : 4
- Tipover Sensor Pitch Angle : 54
Curiously, I have not found an orientation of the MBB that removes this error. Even better would be no Tipover interlock that could kill power say on a steep climb after takeoft. Two questions:
Is there a command that disables this interlock?
How can I get access to be able to this and other desirable changes eg. Disable kickstand interlock?
Thanks fro any help/clues.
-
What year powertrain is this?
-
2018 DSR
-
I was unaware of this being implemented in production machines. I could simply be unaware, but is it possible that you have a prototype setup?
In any case, I would log in and look under the settings to see if you can turn it off, or set the flag to 0 if it is that type of value.
set is the command to see what you have access to.
-
It appears that this dubious feature was added in 2018. It is covered in section 4.3 of the operator’s manual. I just checked and found no mention in the 2017 manual.
Logging in to change this parameter seems like a good idea. (I would disable ABS too). Where can I find out how to get access to the necessary passwords?
Thanks
-
I lay my bikes down fairly frequently trying to learn tricks and the first time I dropped the Zero on concrete I had to reboot to get it working again. But I have a 2017 FXS, so I'm not sure what was going on.
Every time I've dropped the zero on dirt I just pick it up again and ride off without a reset.