ElectricMotorcycleForum.com

General Category => General Discussion => Topic started by: repoman on July 28, 2011, 09:31:58 PM

Title: I am new to the forum
Post by: repoman on July 28, 2011, 09:31:58 PM

I have a belt drive question. 

Can anyong post some pictures of the front and rear belt drive pulleys.  I am currently modifying a Hyosung GV650 to the belt drive of the Zero S bike.

I could also use some general dimensions like belt lenght (I know there are 200 teeth @ 8 mm pitch, belt width of 14 mm).
Diameter of both front and rear pulleys and if possible hole pattern for the bolts for attaching the pulleys.

I believe the belt cost about $59.99 new.  I do not know the cost of the pulleys.

The reason I am attempting this mod is the cost of my current set-up is:

Belt $305
Front pulley $70
Rear pulley $225

Thanks

Title: RE: Hyosung GV650 to Zero S belt conversion
Post by: skadamo on August 05, 2011, 03:03:39 AM

Hey welcome!

Just to be clear, are you keeping the GV650 motor? Just swapping out the pulleys and belt?

Title: Re: I am new to the forum
Post by: repoman on August 06, 2011, 12:52:34 AM

I would like to just swap the pulleys and belt on my GV 650 and keep the engine.

Title: Re: I am new to the forum
Post by: repoman on August 15, 2011, 07:15:05 PM

Is there anyone willing to help me with my original post?

Any help would be appreciated, thanks.

Title: Re: I am new to the forum
Post by: frodus on August 15, 2011, 09:10:02 PM

sorry, there's just not a lot out there. Not many bikes use belt.

Try asking Zero directly if you want specific answers.

Title: Re: I am new to the forum
Post by: repoman on September 12, 2011, 07:57:40 PM

Can anyone give me the center to center dimension of the two pulleys, either chain or belt drive will work as they should be the same distance.

Thanks