ElectricMotorcycleForum.com
Makes And Models => Zero Motorcycles Forum | 2013+ => Topic started by: victor6.7y on June 01, 2024, 09:52:36 PM
-
So I found a possible definition for Error code 23.
I wanted to submit it to: https://zeromanual.com/wiki/Gen2/Error_Codes#23 (https://zeromanual.com/wiki/Gen2/Error_Codes#23) but I am not sure how.
I found out that if your MBB is not in its normal position; when the bike is turned on; it will give an error 23; see the picture :)
You will still be able to drive the bike; but you will see the error 23 and dash error blinking.
This is propably not the only way to get a error 23.
-
I would imagine it's probably the tip over sensor, when the bike is powered on it will run a test to make sure things are as they should be so if the sensor isn't reading what it expects then it would give that error. Any number of things could give the same code.
-
Ah Yes,
Im quite sure it is the tip over sensor. I was facing the error, with a little bit of panick since I took my bike apart. but then I remembered the tipp over sensor.
Therefor I found a way to stop the error from occuring :)