ElectricMotorcycleForum.com

Makes And Models => Zero Motorcycles Forum | 2013+ => Topic started by: Codeh002 on November 07, 2022, 10:50:36 PM

Title: Trying to connect a SB75XBRN cable
Post by: Codeh002 on November 07, 2022, 10:50:36 PM

Hi All, I am trying to install an Sb750XBRN connector so I can use a 3rd party charger. I have crimped the poles onto the end of the wire and pushed them in and heard a "click" everywhere online says the little metal tabs need to fully cover the thin tab. I have pushed and pushed and I cannot get them to go in any further.

Any help on what I might be doing wrong?

Title: Re: Trying to connect a SB75XBRN cable
Post by: Say10 15FX 16FXS on November 07, 2022, 11:13:35 PM

Are they upside down? Meaning the contact has a detent that clicks into the housing spring. It only goes one way. Should click in and you shouldn’t be able to pull it out (unless you release the spring)

Title: Re: Trying to connect a SB75XBRN cable
Post by: Codeh002 on November 08, 2022, 01:54:14 AM

Thanks for the reply, managed to connect with someone who was able to advise me the company sent the wrong pins. I was given SB pins and not SBS pins which are slightly longer.