ElectricMotorcycleForum.com
Makes And Models => Zero Motorcycles Forum | 2013+ => Topic started by: Kappi on April 10, 2022, 02:34:51 PM
-
Hey everybody, I recently attached the OEM to my SR (S/DS platform) and the left side bracket which attaches to the passenger footpeg now blocks the Anderson Plug. Is there a trick to making it fit?
Thanks for your input.
Greetings
Kappi
-
Ok, problem is McGyverd away: After removing one of the two screws in the Anderson receptible on the bike, I can rotate the socket far enough to get the Anderson Plug in, so I am not sitting beside the charging station like a starving man besides a can without opener, however, there must be a more decent solution to the problem.
Any ideas around?
-
Hey everybody, I recently attached the OEM to my SR (S/DS platform) and the left side bracket which attaches to the passenger footpeg now blocks the Anderson Plug. Is there a trick to making it fit?
Thanks for your input.
Greetings
Kappi
Either make or buy & install an extension for the Anderson. Here is what I did to both my 2017 DS and 2017 SR:
-
Thanks Don, I'll try something like your solution.
-
Thanks Don, I'll try something like your solution.
I can charge my 2017 SR at ten KW with the four connectors shown. A 1KW Delta Q on each of the larger Andersons, A 3.3 KW charger on each of the smaller Andersons below (that the red and black wires go to) and along with the 1.4KW OBC. That is a total of 10KW.
The smaller Andersons are wired to the motor controller.
-Don- Auburn, CA