ElectricMotorcycleForum.com

Makes And Models => Zero Motorcycles Forum | 2013+ => Topic started by: GeneralSP on July 27, 2020, 05:19:18 AM

Title: Original led turn signal kit programming
Post by: GeneralSP on July 27, 2020, 05:19:18 AM

Hi folks, somebody can programming my led blinker kit for my SRS, with sharing computer?

My dealer is too far.

In private please for more infos.

Title: Re: Original led turn signal kit programming
Post by: Crissa on July 27, 2020, 05:59:43 AM

It's a secret item on the dealer's interface.

They have a different level password for different abilities.  That password is not known, it's hidden in Zero's software.

-Crissa

Title: Re: Original led turn signal kit programming
Post by: GeneralSP on July 27, 2020, 09:58:35 PM

OK, can I install them with resistor? if yes what is your recommendation about (ohm) or the model for this?

About the software (diag4zero) I have the HEX code to change for the blinkers, that's why I asked for programming!

Title: Re: Original led turn signal kit programming
Post by: Crissa on July 27, 2020, 11:13:18 PM

If you have the software and the right code, then what programming is needed?

If a standard resistor worked, Weiser Technik's relay wouldn't throw random errors.

-Crissa

Title: Re: Original led turn signal kit programming
Post by: GeneralSP on July 28, 2020, 04:24:31 AM

Quote from: Crissa on July 27, 2020, 11:13:18 PM

If you have the software and the right code, then what programming is needed?

If a standard resistor worked, Weiser Technik's relay wouldn't throw random errors.

-Crissa

Unfortunately I don't have this software, if I could found it, I could programming myself because I have all informations HEX code and procedure to make it.

The SRF and S don't have a relay like SR for the blinker.

Title: Re: Original led turn signal kit programming
Post by: Crissa on July 28, 2020, 04:31:58 AM

Weiser Technik lights come with a unit they call a 'relay' that is between the blinker relay and canbus and their lights, so it doesn't throw an error on most bikes.

Hence, if you could just use a resistor, they would be able to avoid the errors.

But instead, there's a secret setting in the software.  And no, it's not publicly available.  As much as that's a sore point, it's the state of things.  You need an authorized dealer.

-Crissa

Title: Re: Original led turn signal kit programming
Post by: Zatopec on March 25, 2021, 11:05:24 PM

Hi folks,
I have a Zero SR/F and I have replaced the original blinkers with other LEDs aftermarket,
I have connected 4 resistors 6.8? 25W in parallel to the wires that feed the LEDs and everything works fine without errors on the dashboard.

Title: Re: Original led turn signal kit programming
Post by: Hans2183 on March 26, 2021, 07:56:47 PM

this document shows what programming is needed but indeed password is unknown https://fotoleer.files.wordpress.com/2021/01/zm10-08294-1_d7.pdf