Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[TNCreator]

Hi, my bike will shut down the whole headlight block and throw an error on the dash if I flash the high beam.
It does work indefinitely if I switch to full high beam but 100% crash after a few seconds when flashing.

I read somewhere that there was a "ballast" thing to replace, does anyone have a link to the part in question ?

thanks !

[Specter]

If the ballast was bad, if there is such a thing for an incandescent or led light, then it'd fault no matter when the light was on.

If it's only faulting when you flash it, that kind of tells me you have a problem with your switch.  Maybe a wire pinched or something and when you flick it, it shorts, causing the fault?  Id look into the switch first for the cause.

Aaron

[PWM]

VCU is sensing an overload when the "flash" mode is invoked - both HiBeam and LoBeam activate together in this mode.

Check to verify illumination between left and right LEDs are the same brightness in both LoBeam and HiBeam sustained modes, something is bum w/ LEDs.