Hi all,
One question about SoC behavior after charging.
To start off, this is for a Ribelle, and the behavior is seen since start of ownership in June.
Typically I charge to 80% (or 90%, or other level < 100%).
If I take the bike right at the end of charging, typically the SoC reading will be on target (programmed 80/reading 80).
If there is a time before I start off (say 2_3 hours) usually the SoC has gone done a few % (say 76%).
Afterwards SoC remain reliable(it doesn't go further down) and also(let say if I stop later at 65 and run the bike again next day it is still at 65).
So basically the behavior is that usually the bike end up after charging with a SoC that is slightly below the target. Does anybody experience a similar behavior?
I have the impression it may have something to do with cell balancing as usually this effect seems less if I have just balanced the cell.
Aside of that, bike runs great so no complain, but I would just like to make sure it is standard behavior and that there is nothing 'behind the scene' going on with the pack that could harm long term reliability.