ElectricMotorcycleForum.com

  • November 13, 2024, 02:39:14 PM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  

News:

Electric Motorcycle Forum is live!

Pages: 1 [2]

Author Topic: KTM 690 kickstand bypass Works with zero?  (Read 992 times)

mcambaza

  • Newbie
  • *
  • Posts: 23
    • View Profile
Re: KTM 690 kickstand bypass Works with zero?
« Reply #15 on: November 24, 2023, 04:50:36 AM »

Best choice!  Resistors are so cheap.

I know its a stupid question for who understands better eletricity... But can I use a multimeter with the 3 wires to check wich one is the ground, the positive 5v and the signal without harming the mbb right? Then I connect the signal with the ground with the resistor, right?
Logged

SwampNut

  • Full Member
  • ***
  • Posts: 233
    • View Profile
Re: KTM 690 kickstand bypass Works with zero?
« Reply #16 on: November 24, 2023, 05:06:20 AM »

A digital meter is perfectly safe to use to test this, an analog may not be.  And of course, don't use the amp/milliamp mode, which is basically a short circuit.  You can use any voltage and resistance modes.
Logged

hutec

  • Newbie
  • *
  • Posts: 2
    • View Profile
Re: KTM 690 kickstand bypass Works with zero?
« Reply #17 on: November 24, 2023, 06:02:38 PM »

first post here , reading for long time.
I have a DS2015 with 45k Km in Germany.
Few weeks ago i had also issue with sometimes bad kickstand switch. I work as EE and often trouble shoot bad electronic.
So just opened the potting and found the bad soldered HAL Sensor.
I resoldered and potted the sensor and it is working again.
Also i drawed a schematic of the sensor.
Here it can be seen that the Hal sensor pulls the pink wire to GND with 2K2
I checked it also and the bike worked with only 2K2 Resistor between pink and black.
But safety first, you should not be able to drive with kickstand down
Logged

atomicdog

  • Newbie
  • *
  • Posts: 27
    • View Profile
Re: KTM 690 kickstand bypass Works with zero?
« Reply #18 on: November 24, 2023, 11:28:21 PM »

Also i drawed a schematic of the sensor.

Thanks for the pictures and info. Is the W60 **** the part number for the hall sensor? I can't make out the other numbers.
Logged
23' SR/S

mcambaza

  • Newbie
  • *
  • Posts: 23
    • View Profile
Re: KTM 690 kickstand bypass Works with zero?
« Reply #20 on: November 25, 2023, 05:40:41 PM »

2.2k and 2.4k resistors works perfectly.. using the bike for 2 days already with no issues.
Logged
Pages: 1 [2]