Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[petewarm]

Hi everyone.  Iv been getting to grips with my SR/F now and starting to explore how I want to change the controls.

And then I noticed that the emergency hazard switch on the LH bar no longer works. Indicators are fine. Earlier when I got he bike, riding in the wet I can remember the flashers coming on without me doing anything, but then the bike got transported back to the Netherlands from the UK and all the wiring rebuilt. 

So I assume that the issue was water in the switch or wiring and wondering if this now has an open circuit failure.  My question is,  how can I test that its the switch rather than the main computer board?  I can see two ways forward:
1) strip the switch off the handle bar and short out the contacts to test the switch.
2) operate the switch and then download the logs and get someone to help me read it.

Any  suggestions gratefully received.

PS  slightly off topic perhaps, but I've got Remmie's excellent extension for the cruise control switch, which makes the operation considerably less dangerous.  If I could trace the wiring, I could swap the hazard indicator switch with the cruise control - much more sensible arrangement.  Anybody got an idea on how to do this  - physically or in software?

good riding all. pete

[Demoni]

I am not familiar with the SR/F but Energica runs the same left hand controls...

Turn either your left or right signals on. When you center push the switch to cancel the signal does it stop blinking?
The cancel function activates the same wires that turn on the hazard lights. The bikes electronics are what differentiate between a short press (cancel) and a long press (hazzards).

If the cancel function still works I suspect that the issue is CanBUS related not a physical issue with the wiring.